|
Except the
studio 27 decal sheet I chose to do some other modifications. They
are as follows:
- Stripped the chrome plating of the frames and swing arms and
painted them Alclad II Higly polished alu.
- Scratch built front fork sensor and axle pin.
- Scratch built right side exhaust pipe heat shielding.
- Painted rear chain sprocket cover, clutch cover, rear mud
guard and right exhaust pipe heat shielding with XF-56 through
mesh over X-18 to get CF effect.
- Covered left heel guard, muffler fastener and the scratch
built right heat shielding with Scale Motorsport CF decal. Also
made muffler ribbons out of the same material.
- Detailed the chain and brake callipers
- Replaced Tamiya tubing with fishing line. .6 mm for clutch and
brake lines and .4 mm for throttle.
- Did some over all weathering and did some cuts in the foot
pegs.
- Black Chrome Bare metal foil on the sliding parts of the front
fork.
On the rcv:s from 2003 and forward there is a heat shield on the
right side wich is not supplied by Tamiya. I copied the part from a
trans kit from Mies Laboratory that I will use on another build. I
painted the plasticard black and added Scale Motorsport carbon fibre.
|
|